Konica Minolta SL1000 - Manual (Page 18)

SL1000 User’s Guide
1-2
1 Precautions for Installation
1.1 Installation Environment
Install the Scanner in a location, which meets the following requirements to ensure safe
operation and utmost performance.
 A well-ventilated place
 An area which is free from ammonia or other organic gases.
 A place which has easy access to a power outlet so that the unit may be easily plugged and
unplugged.
 An area free from direct sunlight
 A place which is out of the direct air stream of an air conditioner, heater or ventilator and is
not subject to extremely high or low temperatures or humidity.
 A stable location with a flat surface that is not subject to undue vibration.
 A place away from curtains or other objects that catch fire and burn easily
 An area that is safe from spilled water or other liquids.
 A dust-free location
1.2 Power Source
The Power Source Voltage Requirements are as follows.
 Use a Power Source with little voltage/frequency fluctuations.
Power Source: 50 Hz – 60 Hz
Voltage Fluctuation: 120 VAC ±10%, 230 VAC ±10%
Frequency Fluctuation: 50 Hz ±3 Hz
60 Hz ±3 Hz
 Be careful not to exceed the capacity of the outlet, especially when sharing other appliances
from the same outlet.
 The outlet should be located near the unit and be easily accessible so that the Power Cord
can be unplugged immediately if necessary.
 NEVER connect any other appliances or machines by means of a multiple socket to the
outlet being used for the unit.
 If an Extension Cord is needed, use one with a capacity greater than the power consumption
of the unit.
 Make sure that the Power Cord and extension cord do not become caught in any mechanism
of the system. Do not allow either the power or extension cord to become caught underneath
the weight of the unit.
1.3 Grounding
Be sure to connect the Ground Wire for the Power Cable to any of the following places to
prevent electrical shocks due to electrical leakage:
 Ground Terminal of the outlet
 Ground terminal that complies with local electrical standards
NOTE :
NEVER connect the Ground Cable to a Gas Pipe, the Ground Wire for a Telephone
Line, or a Water Pipe.