Konica Minolta bizhub C451 - Manual (Page 18)

Using Authentication Unit (Biometric Type) AU-101 3
AU-101 17
Registering users
!
Detail
In order to register users with Data Administrator, this device must be
connected to the USB port of the computer, and the computer and
multifunctional product must be connected over a network.
1
If this device is connected to the multifunctional product, turn off the
multifunctional product with the main power switch, and then
disconnect this device.
– If this device is connected to the computer, continue with step 4.
2
Note
• When the multifunctional product is turned off, then on again with the
main power switch, wait at least 10 seconds to turn the machine on after
turning it off. The machine may not operate correctly if it is turned on
immediately after being turned off.
• Hold the plug when plugging and unplugging the USB cable, otherwise
the cable may be damaged.
2
Turn on the multifunctional product with the main power switch.
3
Connect this device to the USB port of the computer installed with Data
Administrator.
Multifunctional product
Network
Computer
USB
This device