Konica Minolta bizhub C451 - Manual (Page 6)

Using Authentication Unit (Biometric Type) AU-101 3
AU-101 5
3 Using Authentication Unit (Biometric
Type) AU-101
In order to use this device, user finger vein patterns must first be registered
with the machine. A registered user can log on to a multifunctional product
or print a print job after completing authentication with their finger vein
patterns. The following procedures describe how to specify the necessary
settings on the multifunctional product, register users, and perform the logon
and print job operations after completing authentication.
2
Note
Align the index finger with the indentation and notch in the scanner, and
then position the finger so that the tip lightly touches the edge of the
scanner. Place your thumb and middle finger down to hold this device in
place on both sides, and avoid moving the index finger being used for
authentication.
For details on positioning the finger on this device, refer to the Quick
Guide Authentication Unit (Biometric Type AU-101).
Important
- Do not place any object other than your finger in the scanner of this
device while scanning, otherwise the device may malfunction.
- Do not disconnect the cable connecting the device to the computer
while scanning, otherwise the system may become unstable.
3.1 Multifunctional product settings
!
Detail
User authentication on the multifunctional product must be set for
machine authentication.
1
From the control panel of the multifunctional product, touch [User
Authentication/Account Track] on the Administrator Settings screen,
and then touch [General Settings].