Konica Minolta bizhub 200 - Manual (Page 51)

2 Administrator Operations
2-34 200/250/350
Ad
minist
ra
to
r Op
er
at
ions
Chapter 2
2.6.3 Setting the Encryption Key (encryption word)
2
Note
When the main power switch is turned off, then on again, wait at least 10
seconds to turn it on after turning it off. Be sure to allow an interval of 10
sec. or more in order to ensure correct operations.
Turn off the sub power switch
→ Turn off the main power switch → Turn
on the main power switch
→ Turn on the sub power switch
NEVER forget the Encryption Key set through the above procedure. The
Encryption Key must be entered when changing canceling the Encryption
Key .
Do not leave the machine with the Admin. Management mode setting
screen left shown on the display. If it is absolutely necessary to leave the
machine, be sure first to log off from the Admin. Management mode.
<Setting can be made only from the control panel>
0 For the procedure to call the HDD Management to the display, see steps
1 and 2 of “Setting the HDD Lock Password” on page 2-25.
1
Call the HDD Management screen to the display from the control panel.
2
Touch [Encryption Set-
ting].
350_security_E.book 34 ページ ２００６年１１月２０日 月曜日 午前１０時４１分