Konica Minolta bizhub 200 - Manual (Page 89)

3 User Operations
3-22 200/250/350
Use
r Op
er
at
ions
Chapter 3
9
Click the [Apply].
2
Note
If there is a mismatch in the User Box Password between that entered in
the “Password” box and that registered in the machine, a message ap-
pears that tells that the User Box Password entered is wrong. Click [OK]
to go back to the screen of step 8. Then, perform the steps 6 through 9
again.
If the Enhance Security function is set to [ON], the machine counts entry
of a wrong User Box Password as unauthorized access. If a wrong cur-
rently set User Box Password is entered three times, a message appears
that tells that the User Box cannot be accessed for any subsequent entry
of password. The machine is then set into an access lock state. To cancel
the access lock state, the Administrator of the machine must perform the
Unlock operation. Contact the Administrator of the machine.
If the User Box Password entered in the “New Password” box does not
meet the requirements of the Password Rules, a message appears that
tells that the User Box Password entered is wrong. Click [OK] to go back
to the screen of step 8. Then, perform the steps 7 through 9 again.
If there is a mismatch in the User Box Passwords between that entered
in the “New Password” box and that entered in the “Retype New Pass-
word” box, a message appears that tells that there is a mismatch in the
User Box Passwords. Click [OK] to go back to the screen of step 8. Per-
form steps 7 and 9 once again.
350_security_E.book 22 ページ ２００６年１１月２０日 月曜日 午前１０時４１分