Konica Minolta bizhub 200 - Manual (Page 47)

2 Administrator Operations
2-30 200/250/350
Ad
minist
ra
to
r Op
er
at
ions
Chapter 2
2.6.2 Changing the HDD Lock Password
2
Note
When the main power switch is turned off, then on again, wait at least 10
seconds to turn it on after turning it off. Be sure to allow an interval of 10
sec. or more in order to ensure correct operations.
Turn off the sub power switch
→ Turn off the main power switch → Turn
on the main power switch
→ Turn on the sub power switch
Do not leave the machine with the Admin. Management mode setting
screen left shown on the display. If it is absolutely necessary to leave the
machine, be sure first to log off from the Admin. Management mode.
<Setting can be made only from the control panel>
0 To call the HDD Lock Setting screen to the display, see steps 1 through
3 of “Setting the HDD Lock Password” on page 2-25.
1
Call the HDD Lock Setting screen to the display from the control panel.
2
Touch [Change Pass-
word].
3
Enter the currently regis-
tered 20-digit HDD Lock
Password from the key-
board and keypad.
– Press the [C] key to
clear all characters.
– Touch [Delete] to de-
lete the last charac-
ter entered.
– Touch [Cancel] to go
back to the HDD Set-
ting screen.
350_security_E.book 30 ページ ２００６年１１月２０日 月曜日 午前１０時４１分