Konica Minolta bizhub PRO 1050P - Manual (Page 54)

Using Perfect Binder PB-502 (continued)
50
❒ Covers fed from tray 1 to 5 can be simplex- or duplex-printed, while those
loaded in the cover feeding tray of Perfect binder or the upper/lower tray of post
inserter on Folding unit cannot be printed.
❒ Cover Trimming function trims the cover by the amount automatically estimated
from the following formula, in the range from 3 mm to 40 mm in 0.1 mm
increments.
(Cover width) – (Body width × 2) – (Spine width)
If the estimated amount exceeds 10 mm, perfect binder will trim the cover
automatically whether this function is activated or not.
❒ Fine Adjustment
Cover Lead Edge Adjustment adjusts the position of front cover and body set in
widthwise direction in the range from –12.8 mm to +12.8 mm in 0.1 mm
increments.
Cover Trimming Adjustment adjusts the trimming width in the range from –5.0
mm to +5.0 mm in 0.1 mm increments.
Cover Image Shift Adjustment adjusts the position of image to be printed on
the front cover when using Cover Print mode.
❒ For specifications of the secondary (sub) tray, see p. 64, p. 66 and p. 70.
*
1
: Specify the custom size of covers from the Perfect Binding Screen. For
details, see p. 55.
*
2
: For 8.5" × 11" body set to be bound with a cover sheet fed from tray 1 to 5,
the maximum thickness will be less than 30 mm.
Cover Trimming Off: 460 – (216 × 2) = 28 mm
Cover Trimming On: 460 – (216 × 2) – (Trimming width 3 mm) = 25 mm
If thickness of 8.5”×11” body set is more than that mentioned above, use
the cover feeding tray of Perfect binder or the tray of post inserter on
Folding unit to attach a cover.
*
3
: You can specify the paper weight available for body sets and covers in
Perfect Binding mode. For details, see POD Administrator’s reference, p. 5-
26.
*
4
: The minimum/maximum number of sheets to be bound in Perfect Binding
can be changed according to the paper weight of body set. For details, see
POD Administrator’s reference, p. 5-27.
Also, the machine can be set to detect the thickness of body set and to stop
the binding operation temporarily if the width of the cover to be used is
unsuitable for the body set. For details, see POD Administrator’s reference,
p. 5-28.