Konica Minolta bizhub 500 - Manual (Page 74)

Administrator Operations 2
500/420 2-55
Ad
minist
ra
to
r Op
er
at
ions
Chapter 2
2.10.2 Changing the HDD Lock Password
2
Note
When the main power switch is turned off, then on again, wait at least 10
seconds to turn it on after turning it off. if there is no wait period between
turning the main power switch off, then on again, the machine may not
function properly.
Here is the sequence, through which the main power switch and sub
power switch are turned on and off:
Turn off the sub power switch
→ Turn off the main power switch → Turn
on the main power switch → Turn on the sub power switch
Do not leave the machine with the Administrator Setting mode setting
screen left shown on the display. If it is absolutely necessary to leave the
machine, be sure first to log off from the Administrator Setting mode.
<Setting can be made only from the control panel>
0 To call the HDD Lock Password entry screen to the display, see steps 1
through 3 of “Setting the HDD Lock Password” on page 2-52.
1
Call the HDD Lock Password entry screen to the display from the con-
trol panel.
2
Enter the currently registered 20-digit password from the keyboard and
keypad.
– Press the [C] key to clear all characters.
– Touch [Delete] to delete the last character entered.
– Touch [Shift] to show the upper case/symbol screen.
– Touch [Cancel] to go back to the HDD Setting screen.
420_security_E.book 55 ページ ２００７年３月７日 水曜日 午後３時１５分