Konica Minolta bizhub 421 - Manual (Page 158)

501/421/361 7-10
Explanation of reports/lists 7
7.3.2 TX Result report
Transmission results are automatically printed out. In the Administrator Settings screen in the Utility mode,
the printing interval can be selected from "ON", "If TX Fails", and "OFF".
Result OK: Printed when transmission has completed successfully
S-OK: Printed when transmission is aborted
PW-OFF: Printed when the power is switched off during transmission
TEL: Printed when a phone call is received
NG: Printed when a transmission error has occurred
Continue: Printed when a transmission error has occurred and the job has been put
in a queue for redial (error page redial)
No response: Printed when the recipient does not respond
Busy: Printed when the recipient line is busy and transmission is disabled
Memory full: Printed when the fax file memory becomes full and reception has failed
LOVR: It is indicated when receiving page length exceeds 1,000 mm. (IP address
fax/Internet fax)
POVR: The upper limit of received pages is exceeded. Printed when the number of
received pages has exceeded 3,000 pages (IP address fax/Internet fax)
FIL: File error. Printed when the type of the received file is not supported (IP address
fax/Internet fax)
DC: Decoding error. Printed when an error has occurred while decoding the received
file (IP address fax/Internet fax)
MDN: Printed when an error has occurred during MDN response reception (Internet
fax)
DSN: Printed when an error has occurred during DSN response reception (Internet
fax)
Remarks One of the following is printed.
L1: Main line
TMR: Timer TX
ORG: Original size specified
MIX: Mixed mode transmission
CSRC: Remote diagnosis
PC: PC-FAX
SP: Special Original
RTX: Resending
MBX: Confidential
L2: Auxiliary line
POL: Polling
FME: Transmission with the frame erased
CALL: Manual transmission
FWD: Forwarding
BND: Binding position of the original
FCODE: F code specified
RLY: Relay
BUL: Bulletin
IPADR: IP address fax
I-FAX: Internet fax
Item Description