Konica Minolta bizhub 421 - Manual (Page 108)

501/421/361 4-55
Transmitting data 4
4.5.17 Application - TX Stamp (G3/IP/I-FAX)
TX Stamp
When sending a document using the ADF, a TX Stamp can be printed on the original after it is scanned to
enable page-by-page checking that scanning has succeeded. When sending a double-sided original, a TX
stamp is only printed on the front page.
When [TX Stamp] is enabled, a stamp with a diameter of 4 mm is printed in pink at the position shown in the
figure.
To enable printing a stamp, the optional stamp unit is required.
The stamp ink is a consumable item. If the stamp color becomes faint, contact your service representative.
When the original is mixed, the stamp position may be displaced from the point shown in the figure.
To check that the original is successfully transmitted, refer to the transmission report or the transmission
result that appears on the setting confirmation screen.
Printing a TX stamp
Select [TX Stamp] on the Application screen.
Front surface of original
Original transmitting
direction
Stamp
position