Konica Minolta bizhub 421 - Manual (Page 113)

501/421/361 4-60
Transmitting data 4
V. 34 OFF
V. 34 is a communication mode used for super G3 fax communication. There are cases when the
communication is not possible in super G3 mode depending on the telephone line conditions when the
recipient’s machine or this machine is connected to the line via a private branch exchange.
It is recommended that you set V. 34 to off before sending a fax. This machine automatically returns to V. 34
mode when it completes transmission.
!
Detail
This function cannot be used together with the following functions.
Polling RX
Polling TX
Bulletin Registration
Bulletin Polling RX
ECM OFF
Check Dest. & Send
A fax is sent only after a comparison of the specified fax number with the fax number information (CSI) for
the recipient’s machine indicates a match. This prevents misdirected transmissions since a transmission
error occurs if the numbers do not match.
!
Detail
To execute [Check Dest. & Send], the destination must have its fax number registered.
Select Line
Select [Line 1] or [Line 2] to send a fax if the optional fax multi line is installed. Specify a line for transmission.
When “Unset” is chosen in Select Line, transmit using the line which is then vacant among Line 1 or Line 2.
When the Line 1 and the Line 2 are both vacant, priority is given to the Line 1.
!
Detail
You cannot specify a line when "Line 2 Setting" of "Multi Line Setting" is set to "RX Only".
When two lines are used separately as an outside line and an extension, be sure to specify a line to be
used. Selecting [Unset] may result in an incorrect transmission.