Firmware rewriting, 1 outline, 2 usb memory – Konica Minolta BIZHUB C360 User Manual
Page 32: 1 preparation, 2 procedure, Preparation, Procedure
10. Firmware rewriting
Security Function Ver. 1.02 Jul. 2010
28
bizhub C360/C280/C220
for PKI Card System
Security Function
10. Firmware rewriting
10.1 Outline
• There are two ways to update the firmware: One is by directly connecting with the main
body using the USB memory device, and the other is by downloading over a network
using the Internet ISW.
NOTE
• When rewriting the firmware, it is necessary to execute the following steps to
rewrite the firmware.
The BootROM rewriting and the loadable device driver/OCR dictionary installing
should be executed as necessary depend on the firmware type or usage environ-
ment.
1.
Touch [BootRom] in the firmware update item display, and touch [START].
2.
Check the message “BootRom Update completed successfully”, and touch [OK].
3.
Rewrite the firmware data.
4.
Select [Service Mode]
[System 2] [Data Install], and update the movie data to the
new version.
5.
Select [Service Mode]
[System 2] [Software Switch Setting].
6.
Touch [Switch No.] and enter “25” with the ten-key pad.
7.
Touch [HEX Assignment] and enter “20” with the ten-key pad.
8.
Touch [Fix].
9.
Turn OFF and ON the main power switch and sub power switch.
10. Install the loadable device driver as occasion demands.
11. Install the OCR dictionary data for the searchable PDF as occasion demands.
10.2 USB memory
10.2.1
Preparation
• Conditions for USB memory which can be used for updating the firmware are as follows:
- Without security function added (security function can be turned off)
- Memory with 1 GB to 2 GB are recommended (One with 4 GB or more may not oper-
ate)
- Corresponds to USB 2.0
- Formatted with FAT32 type
10.2.2
Procedure
1.
Connect the USB to the PC, and copy the firmware data to the USB memory.
NOTE
• The firmware data to be updated must be copied to the root directory with the file
name “A0EDFW. tar.”
• More than one firmware data with a single model or multiple models can be stored
in the USB memory. (Maximum of fifteen files)
When storing more than one firmware data, make a folder with a name “(model
code) FW” (“A0EDFW” for this machine) right under the root directory.
(File names can be set arbitrarily)
• When making a folder and storing more than one firmware data, it is also neces-
sary to copy the firmware data “A0EDFW. tar” to the root directly.
2.
Turn OFF the main power switch and the sub power switch.
3.
Remove the screw [1].