Konica Minolta BIZHUB C360 - Manual (Page 39)

Security Function Ver. 1.02 Jul. 2010 13. FAX function
35
bizhub C360/C280/C220
for PKI Card System
Security Function
B. Caution when performing dial transfer
After setting the country code, dialing operations may be selected after the switchboard dial
tone is detected depending on the destination. In this case, depending on the switchboard
connected to the machine and the type of dial tone received from the switchboard, dialing
operations may not be available.
If that happens, you may be able to avoid the problem with the following setting.
(1) Turn the Dial Tone Detection function OFF
1.
Display the Service Mode screen.
2. Touch “FAX.”
3. Touch “NetWork.”
4. Touch “Network Setting 2.”
5. Touch “OFF” of Dial Tone Detection.
6. Touch “END.”
7. Touch “Exit” on the Service Mode screen.
8. Turn OFF and ON the Main Power Switch.
C. Affixing the labels
1.
Affix the label furnished with the kit to the position shown below.
2. Affix the label (Super G3 label) furnished with the machine to the position shown below.
D. Setting the FAX (circuit 2)
1.
Plug the power cord into the power outlet and turn on the machine.
2. Display the Service Mode screen.
3. Touch “System 2.”
4. Touch “Option Board Status.”
5. Touch “Set” of FAX (circuit 2).
6. Touch “END.”
7. Touch “FAX.”
8. Touch “Line2.”
9. Touch “Initialization.”
10. Touch “Fax Function Parameter.”
11. Touch “Yes.”
12. Touch “Yes.”
13. Touch “END.”
14. Touch “Exit” on the Service Mode screen.
15. Turn OFF and ON the Main Power Switch.
16. Perform the sending and receiving tests between the Machine and either the store
which offers the service or the local retailer, to check that it can be operated normally.