3 action when data transfer fails, Action when data transfer fails – Konica Minolta BIZHUB C360 User Manual
Page 35
Security Function Ver. 1.02 Jul. 2010
10. Firmware rewriting
31
bizhub C360/C280/C220
for PKI Card System
Security Function
13. Call the Service Mode to the screen.
14. Select [Firmware Version].
15. Make sure if the version of firmware is updated.
10.2.3
Action when data transfer fails
• If “NG” appears on the control panel, indicating that rewriting has been unsuccessful (in
which case the Start key lights up red), take the following steps.
1.
Perform the data rewriting procedure again.
2.
If the procedure is abnormally terminated, change the USB memory for a new one and
try another rewriting sequence.
3.
If the procedure is still abnormally terminated, change the board that has caused “NG”
and carry out data rewriting procedure.
A0EDS1E042DA
F/W to be updated
Appropriate board
Remark
MFP CONTROLLER
MFP board (MFPB)
SCANNER
MFP board (MFPB)
PRINTER
Printer control board (PRCB)
FAX BOARD CONTROLLER1 Fax board (Main)
Only when the FK-502 is mounted
FAX BOARD CONTROLLER2 Fax board (Sub)
Only when the FK-502 is mounted
ADF (DF-M)
DF control board (DFCB)
FINISHER
FNS control board (FSCB)
Only when the FS-527/529 is
mounted
RU
Transfer control board (TRCB)
SD
SD drive board (SDDB)
Only when the SD-509 is mounted
DSC1
DSC board
Only when the SC-507 is mounted
DSC2
Not used