Konica Minolta PageScope Net Care Device Manager - Manual (Page 108)

Device List 3
Device Manager 3-78
<SNMP Settings>
SNMP Broadcast Discovery Devices can be searched for with a broadcast transmis-
sion. The search can be performed quickly, but devices in-
compatible with broadcasting cannot be found.
Using all added (specified) settings, broadcast discovery is
performed. Broadcast addresses can be added or deleted.
To delete an IP address, select the check box for the set-
ting to be deleted.
For details on adding broadcast addresses, refer to "Add-
ing an SNMP broadcast discovery" on page 3-80.
For details on deleting broadcast addresses, refer to "De-
leting settings" on page 3-85.
SNMP Unicast Discovery A search can be performed by sending an SNMP request
to all addresses within the search range. This search is not
performed quickly, but it is performed accurately.
Using all added (specified) settings, unicast discovery is
performed. IP address ranges can be added or deleted. To
delete an IP address, select the check box for the setting to
be deleted.
For details on adding an IP address, refer to "Adding an
SNMP unicast discovery" on page 3-81.
For details on deleting an IP address, refer to "Deleting set-
tings" on page 3-85.
SNMP Multicast Discovery A search can be performed by sending an SNMP request
to all addresses belonging to the multicast group. Load to
the network can be reduced, but the router being used
must support the IPv6 multicast.
Using all added (specified) settings, multicast discovery is
performed. Multicast addresses can be added or deleted.
To delete an IP address, select the check box for the set-
ting to be deleted.
For details on adding multicast addresses, refer to "Adding
an SNMP multicast discovery" on page 3-83.
For details on deleting multicast addresses, refer to "Delet-
ing settings" on page 3-85.
Function Details
Function Details
SNMPv1 Settings Specify the settings (community name and port number) to
be used with the SNMPv1 protocol during an SNMP broad-
cast discovery/SNMP unicast discovery/SNMP multicast
discovery. Using all added (specified) settings, discovery is
performed. SNMPv1 settings can be added or deleted. To
delete an IP address, select the check box for the setting to
be deleted.
For details on adding settings, refer to "Adding SNMPv1
settings" on page 3-84.
For details on deleting settings, refer to "Deleting settings"
on page 3-85.