Konica Minolta bizhub C250P - Manual (Page 51)

2 Administrator Operations
2-34 C250P
Ad
minist
ra
to
r Op
er
at
ions
Chapter 2
2.7.2 Changing the HDD Password
2
Note
When the main power switch is turned off, then on again, wait at least 10
seconds to turn it on after turning it off. if there is no wait period between
turning the main power switch off, then on again, the machine may not
function properly.
Do not leave the machine with the Admin. Setting mode setting screen
left shown on the display. If it is absolutely necessary to leave the ma-
chine, be sure first to log off from the Admin. Setting mode.
<Setting can be made only from the control panel>
0 For the procedure to call the HDD Password screen to the display, see
steps 1 through 4 of “Setting the HDD Password” on page 2-30.
1
Call the HDD Password screen to the display from the control panel.
2
Press the [Menu/Select] key.
3
Press the [+] and/or [,] key to enter the currently registered 20-digit
HDD Password.
– Press the [*] or [)] key to move the cursor (digit).
– Press the [*] key to clear the value entered.
4
Press the [Menu/Select] key.
? What happens if there is a mismatch in the HDD Passwords?
% If there is a mismatch in the HDD Passwords, a message appears
that tells that there is a mismatch in the HDD Passwords. Enter the
correct password.
c250P_security_E.book 34 ページ ２００７年４月１０日 火曜日 午後７時２７分