Konica Minolta SD-501 - Manual (Page 49)

05 Saddle Stitcher Adjustment (continued)
3-13
06 Fold Paper Width Adjustment
Perform this adjustment if folding position processed by the SD-501 Saddle Stitcher
dislocates in the folded set.
Procedure
1 Touch Adjustment - 02 Finisher Adjustment - 05 Saddle Stitcher Adj.
2 Touch 06 Fold Paper Width Adjustment to display the Fold Paper Width
Adjustment Screen.
3 Touch the COPY tab to display the Copy Screen.
4 Load the desired size of paper to be adjusted on a tray, specify the number of
sheets to 5, then press [Start]. A sample pattern will be output.
5 Check that any dislocation is found in the output set.
6 If the desired result cannot be obtained, touch the ADJUSTMENT tab.
7 Touch Next or Back to select the paper size to be adjusted.
Touching Next continuously will change the paper size as follows.
All Size - 11x17 - A3 - B4 - 8.5x14 - A4R - 8.5x11R - B5R - 8x13 - 8.12x13.2 -
8.5x13 - 8.25x13 - 8K - 16KR - 12x18 - A3W - B4W - A4WR - B5WR - 12x18W -
11x17W - 8.5x11WR - Special
8 Use the touch panel keypad to enter the desired adjustment value, then touch Set.
Available range: -20 (wide) to +20 (narrow), 1 step = 0.1 mm
Note:
If the setting is too wide, the distance of misalignment may be larger.
9 Repeat the adjustment steps from 3 to 8 until the desired result is obtained.
10 If adjustment in any other size is required, repeat steps 3 to 8.
11 Touch Return to restore the Saddle Stitcher Adjustment Mode Menu Screen.