Konica Minolta FK-502 - Manual (Page 383)

Utility mode 10
C451 10-77
6
Set “Output Method”.
– [Forward & Print]: The received original is forwarded and this ma-
chine prints the original.
– [Forward & Print (If TX Fails)]: The received original is forwarded and
when it cannot be forwarded, this machine prints the original.
7
Touch [Forward Dest.] and enter the fax number of the recipient to
whom the received original is to be forwarded.
– Using the control panel keypad or the keyboard that appears in the
touch panel, type in the fax number of the forwarding destination.
– To select a registered address book destination or a group destina-
tion, touch [Select from Address Book].
– If the fax multi line kit has been installed, touch [Select Line] to se-
lect the telephone line.
– Only the fax number can be entered directly (maximum of 38 digits).
– [Tone], [Pause], [-] can be used. Refer to “Fax number input proce-
dure of the destination specification by direct input”, for how to use
these buttons. Refer to “Specifying by direct input” on page 2-24
for the destination specification by the direct input.
– The forwarding destination can be selected from the list of regis-
tered destinations by touching [Select from Address Book]. Regis-
tered fax, e-mail, user box, SMB, FTP, Internet fax or IP address fax
destinations can be selected.
– In order to use the Internet fax and the IP address fax functions, a
technical expert must specify the settings. Contact your service
representative for details.
– When [C] (clear) key is pressed, all entered contents are deleted.
8
Touch [OK].
The settings are changed.
9
Touch [Close] until it returns to Fax/Scan screen.