Konica Minolta Bizhub 215 - Manual (Page 23)

bizhub 215 3-7
3.4 Manual installation using the Add Printer Wizard 3
3.4 Manual installation using the Add Printer Wizard
3.4.1 Windows Vista/7/Server 2008/Server 2008 R2
This chapter describes the procedure for installing the Windows printer driver using the standard Windows
Add Printer function, without using the installer.
For network connection (LPR/Port 9100)
In Windows Vista/7/Server 2008/Server 2008 R2, you can install the printer driver either by searching for the
printer on the network, or by creating a new printer port.
Settings for the machine
To use Port 9100 or LPR printing, you must configure the network settings for the machine in advance.
d
Reference
For details on the network settings of this machine, refer to "Network settings" and PageScope Web Con-
nection - [Network] - [TCP/IP Configuration] and [Network]-[IPv4 Configuration] of [User's Guide Network
Administrator].
Installing the printer driver by searching for the printer using the Add Printer Wizard.
0 Administrator authority is required for installation.
0 Since the printer is searched for during the installation, be sure to connect this machine to the network
before turning it on.
1
Insert the printer driver CD-ROM into the CD-ROM drive of the computer.
% The required CD-ROM varies depending on the printer driver. Select the CD-ROM corresponding
to the printer driver used.
2
Click [Start], then [Control Panel].
3
Select the desired printer function in [Hardware and Sound].
% In Windows Vista/Server 2008, click [Printers] under [Hardware and Sound]. If [Control Panel] is dis-
played in Classic View, double-click [Printers].
% In Windows 7/Server 2008 R2, click [View devices and printers] under [Hardware and Sound]. If
[Control Panel] appears in the icon display, double-click [Devices and Printers].
4
On the toolbar, click the additional functions of the printer.
% Click [Add a printer] on the toolbar.
The [Add Printer] wizard appears.
5
Click [Add a network, wireless or Bluetooth printer].
Connected printers are detected.
% If no printer is detected, turn this machine off, then on again.
In this case, turn off the printer, and then wait approximately 10 seconds before turning it on again.
If you turn this machine on immediately after turning it off, it may not function correctly.
Items to be configured Description
IP address In [NETWORK SETTING] on the Control Panel of this machine, spec-
ify the IP address.
RAW port number To use Port 9100 printing:
In [IPv4 Configuration] for the machine, enable the RAW port number
(initial setting: [9100]).
LPD Setting To use LPR printing:
From [TCP/IP Configuration] - [LPD Setting] for the machine, enable
LPD printing.