Konica Minolta KIP Color 80 - Manual (Page 111)

1-106
2. Check if the mis-fed is cut or not by pulling from
between the Transportation Unit 3 & 4.
Whether the media is cut or not decides what to do
next.
• If the mis-fed media is cut and can be removed
from the machine easily, proceed to the
following procedure 3.
• If it has not been cut yet so can not be
removed from the machine, jump to the
procedure 5. (Procedures 3 and 4 are not
needed.)
3. After removing the mis-fed media from the
Transportation Unit 3 region, close all the
Transportation Units except for the Transport Unit 4.
Transportation
Unit 4
NOTE
Large green cylinder called “Photoconductive Drum” is inside of each Transportation Unit. It is
the most important part to get a good print image, so no dirt or no damage must be given to it.
• Touching onto its surface will provide a fingerprint. Do not touch the surface of Drum
when removing the mis-fed media.
• Contacting a hard material thing onto its surface will result in a scratch mark. Take off
the watch, the ring and some other hard material thing before removing the mis-fed
media.
NOTE
Close the Transportation Units 1-3 surely and gently. The inside part of machine may be
damaged if closed roughly. And the Transportation Units may not be locked firmly if not closed
surely.