Konica Minolta KIP Color 80 - Manual (Page 94)

1-89
3. 2. 6 Mis-feed around the Cutter Region
(Code: J-0111, J-0211 & J-0411)
When the roll media is mis-fed around the Cutter region, any of J-0111, J-0211 and J-0411 is
indicated. (Refer to the following section picture for the location of mis-fed media.)
Cutter region
Remove the mis-fed media as instructed in below.
1. Open the Transportation Unit 4 on the back.
2. Check if the media is found inside of the machine. Whether or not the media is found decides
what to do next.
• If the media is found as the following left photo, proceed to the next procedure 3 to cut the
roll media.
• If it is not found, no more operation is required. Just close the Transportation Unit 4.
The concerned roll deck automatically rewinds the leading edge to the print start position.
Media is found Media is not found
Transportation
Unit 4
Media