Xerox WorkCentre M118i-6288 - Manual (Page 111)

Properties
Xerox CopyCentre/WorkCentre 118 User Guide 111
Protocol Settings IPP
This page allows you to configure the following options when
using IPP (Internet Printing Protocol).
Port Number – The default IPP port number 631 will be
displayed. This is a display-only item.
Add Port No. – Enter the port number.
TBCP Filter – This is only displayed when PostScript is
enabled.
Administrator Mode – Allows you to enable/disable to
operate by the Key Operator.
DNS – Allows you to configure whether to enable/disable
DNS.
Connection Time-Out – Specifies the time-out period when
transmission fails.
Port9100
This page allows you to configure the time-out settings for
the Port9100.
Port Number – Enter a value for the port number between
8000 and 9999.
TBCP Filter – This is only displayed when PostScript is
enabled.
Connection Time-Out – Specifies time-out period when
transmission fails.
UPnP
This page allows you to configure the UPnP protocol.
Port Number – Enter the port number 80, or between 8000
and 9999 that receives requests from the browser.
SSDP:
Allows you to configure the SSDP protocol used for UPnP.
• Valid Advertising Period – Specify the displayed time of
the machine on the network between 60 and 4320
minutes in 1 minute increments.
• Maximum TTL - Enter the maximum TTL between
1 and 10.
E-mail
IP Address or Host Name – Up to 256 characters can be
entered, including . (period) and - (hyphen). If host name is
used, DNS information MUST BE populated correctly.
Max. No. of Pages for Split Send – Allows you to set the size
of outgoing e-mail in pages. You can specify a number
between 0 to 999 pages in 1 page increments. If 0 is
specified, outgoing e-mails will not be split.
POP User Name – Allows you to configure the POP user
address.
POP User Password – Enter the POP user password. Up to
64 characters can be entered.
Re-enter Password – Allows you to verify the configured
password by re-entering the same password.
Feature name Setting items