Xerox WorkCentre M118i-6288 - Manual (Page 67)

Specifying Destinations
Xerox CopyCentre/WorkCentre 118 User Guide 67
Program List
Allows you to select from the list of programs registered in Fax Program.
NOTE: You cannot select a Fax Program if a destination is already specified.
Search by Index
Allows you to locate a destination by the index character assigned to the destination
when registered in Speed Dial.
Follow the steps below:
1. For Entry Mode, switch between [Alphabet] for a letter and [Number] for a number
using the <Select> button.
2. Enter an index character using the alphanumeric keypad.
3. Select [Confirm] using the <Select> button or press the <Enter> button. The list of
addresses that match the entered index displays.
Speed Dial
This feature allows you to dial quickly using a 3-digit code assigned to the destination.
For example, if you register the fax number to Speed Dial code 123, you need only to
enter "123" to automatically dial that registered fax number. You can register up to 200
Speed Dial codes. When you register Speed Dial codes 001-036, their codes are
automatically assigned to One Touch buttons on the control panel. Speed Dial codes
are listed and can be searched for in the Address Book. For more information on how
to register Speed Dial codes, refer to Speed Dial in the Setups chapter on page 159.
1. Press the <Speed Dial> button on the
control panel.
2. Enter a 3-digit code.
NOTE: If the 3-digit code entered is correct, the destination is displayed. If it is
incorrect, you are prompted to re-enter a 3-digit code.
One Touch Dial
This feature allows you to select preset Speed Dial codes 001-036 or Fax Programs
p01- p18 using One Touch buttons. One Touch Dial consists of the following three
pages and you can change the page using the flip cards.
• Page 1 displays Speed Dial codes 001–018.
• Page 2 displays Speed Dial codes 019–036.
• Page 3 displays Fax Programs p01–p18.
<Speed Dial> button