Xerox WorkCentre M118i-6288 - Manual (Page 139)

Print Settings
Xerox CopyCentre/WorkCentre 118 User Guide 139
• Port Status – Specify whether to [Enable] or [Disable] the port status of NetWare.
• Transport Protocol – Specify the transport protocol to be used for NetWare. Select
[TCP/IP], [IPX/SPX], or both.
• Print Mode - Specify the method used to process print data (applied print language).
When [Auto] is selected, the machine automatically detects the print language of the
data received, then interprets and prints the data correctly. When [PCL] or [PS] is
selected, the data received from the PC is processed as each of these respective
data types.
• PJL – PJL commands are required when printing using the print driver. Specify
whether to [Enable] or [Disable] PJL commands that are sent from the PC.
• No. of searches – Specify how many times the file server is searched. Specify a
value between 1 and 100 in increments of 1, or set it to [No Limit]. To specify a value,
select [Number of times], and then enter the value.
• TBCP Filter – Specify whether to [Enable] or [Disable] the TBCP filter when the
PostScript data is processed.
SMB
Use to set up SMB.
• Port Status – Specify whether to [Enable] or [Disable] the port status of SMB.
• Transport Protocol – Specify the transport protocol to be used for SMB. Select [TCP/
IP], [NetBEUI], or both.
• Print Mode - Specify the method used to process print data (applied print language).
When [Auto] is selected, the machine automatically detects the print language of the
data received, then interprets and prints the data correctly. When [PCL] or [PS] is
selected, the data received from the PC is processed as each of these respective
data types.
• PJL – PJL commands are required when printing using the print driver. Specify
whether to [Enable] or [Disable] PJL commands that are sent from the PC.
• TBCP Filter – Specify whether to [Enable] or [Disable] the TBCP filter when the
PostScript data is processed.
IPP
Use to set up IPP.
• Port Status – Specify whether to [Enable] or [Disable] the port status of IPP.
• Print Mode - Specify the method used to process print data (applied print language).
When [Auto] is selected, the machine automatically detects the print language of the
data received, then interprets and prints the data correctly. When [PCL] or [PS] is
selected, the data received from the PC is processed as each of these respective
data types.
• PJL – PJL commands are required when printing using the print driver. Specify
whether to [Enable] or [Disable] PJL commands that are sent from the PC.