AEG BE2003021W - Manual (Page 29)

10.1 Pyrolytic cleaning
Remove all accessories and re-
movable shelf supports.
Do not start the pyrolytic
cleaning if:
• You did not remove the shelf
supports or telescopic shelf
runners (if supplied). In some
models, the display shows
“C1” when this error occurs.
• You did not fully close the
oven door. In some models,
the display shows “C3” when
this error occurs.
1. Remove the worst dirt manually.
2. Set the Pyrolytic cleaning function.
Refer to "Oven functions".
3. When flashes, press or to
set the necessary procedure:
– P1 – If the oven is not very dirty.
The procedure is 1:30 h long.
– P2 – If you cannot easily remove
the dirt. The procedure is 2:30 h
long.
After 2 seconds the procedure
starts.
To change the default length of the
procedure (P1 or P2), press
to set
, and then press or to set
the length of the pyrolytic proce-
dure.
You can use the End function to de-
lay the start of the cleaning proce-
dure.
When the oven is at its set tempera-
ture, the door locks. The display
shows the symbol
and the bars of
the heat indicator until the door un-
locks.
During pyrolytic cleaning the
lamp is off.
Cleaning reminder
To remind you that the pyrolytic clean-
ing is necessary, PYR flashes in the dis-
play for 10 seconds after each activation
and deactivation of the appliance.
The cleaning reminder goes
out:
• After the end of the Pyrolytic
cleaning function.
• If you press “ " and “ ”
at the same time while PYR
flashes in the display.
10.2 Shelf supports
Removing the shelf supports
You can remove the shelf supports to
clean the side walls.
1. Pull the front of the shelf support
away from the side wall.
ENGLISH
29