AEG AG943 - Manual (Page 4)

4
Unpacking and assembly
Charging station
1. Check that all parts are in the box. Fit the handle
by carefully inserting it into the lower main body.
Make sure that the cable does not jam.
2. Secure the handle by tightening the locking screw
supplied. Use a screwdriver or a coin.
1. Position the charging station well away from
heat sources, direct sunlight or wet places. Insert
the adaptor into the mains and connect it to the
charging station.
2. On the bottom of the charging station there is a
hollow space where unused cable can be wound.
3. The wall unit can also be mounted on a wall.
Separate it from the floor unit. Always ensure that
the wall can withstand the weight of Ergorapido.
Unpacking and assembly