AEG AG943 - Manual (Page 8)

8
The brush roll, the hose and the wheels may need to
be cleaned if they become blocked or jammed for any
reason.
Some Ergorapido models are equipped with
BRUSHROLLCLEAN™ TECHNOLOGY – a brush
cleaning function that helps to keep a clean brush
easily.
Please note that the BRUSHROLLCLEAN™
TECHNOLOGY function might not be able to remove
thick threads, wires or thick carpet fibres caught in the
brush roll.
It is recommended to use this function once a week.
For best results use the BRUSHROLLCLEAN™
TECHNOLOGY function when the Ergorapido is fully
charged.
1. Make sure the cleaner is switched on and
stands on hard even surface. Do not use the
BRUSHROLLCLEAN™ TECHNOLOGY function on
deep carpets or long haired rugs.
2. Press the BRUSHROLLCLEAN™ TECHNOLOGY
button with your foot while the cleaner is switched
on. Hold for ca. 5 seconds or until all dirt and hair
is removed. Release the button.
There will be a cutting noise during this process,
this is normal
Cleaning the brush roll with the BRUSHROLLCLEAN™ TECHNOLOGY function*
Cleaning
* Certain models only
When the button is released, the brush is rotating and the nozzle front lights are on again. You can continue to use the Ergorapido for vacuuming as usual. The
BRUSHROLLCLEAN™ TECHNOLOGY function will remain disabled. To reset, the Ergorapido must be charged continuously for at least 10 minutes in the charging stand.
1. Ergorapido plus:
If - while holding the BRUSHROLLCLEAN™
TECHNOLOGY button pressed down – the brush
stops rotating, the nozzle front lights switch off
and the battery indicator light blinks red and blue,
release the BRUSHROLLCLEAN™ TECHNOLOGY
button.
2. Ergorapido:
If - while holding the BRUSHROLLCLEAN™
TECHNOLOGY button pressed down – the brush
stops rotating and the nozzle front lights switch off,
release the BRUSHROLLCLEAN™ TECHNOLOGY
button.
The BRUSHROLLCLEAN™ TECHNOLOGY function
is equipped with an overheating protection. It will
deactivate the brush roll if the BRUSHROLLCLEAN™
TECHNOLOGY function has been activated for more
than 30 sec (constant or interrupted) within one
discharging period.