Olympus SP-570 UZ - Manual (Page 76)

76
EN
Getting to know your camera better
When you get an error message on the camera
Monitor indication Possible cause Corrective action
q
CARD ERROR
There is a problem with the
card. This card cannot be used. Insert a new
card.
q
WRITE PROTECT
Writing to the card is
prohibited. The recorded image has been protected
(read-only) on a computer. Download the
image to a computer and cancel the read-
only setting.
>
MEMORY FULL
The internal memory has no
available memory and
cannot store any new data. Insert a card or erase unwanted data.
Before erasing, backup the data of
important pictures onto the card, or
download such pictures to a computer.
q
CARD FULL
The card has no available
memory and cannot store
any new data. Replace the card or erase unwanted data.
Before erasing, download important
pictures to a computer.
L
NO PICTURE
There are no pictures in the
internal memory or on the
card. The internal memory or the card contains
no pictures.
Record pictures.
r
PICTURE ERROR
There is a problem with the
selected picture and it
cannot be played back on
this camera. Use image processing software to view the
picture on a computer. If that cannot be
done, the image file is damaged.
r
THE IMAGE CANNOT
BE EDITED
If pictures taken by other
cameras are selected, they
cannot be edited. Use image processing software to edit the
pictures.
CARD-COVER OPEN
The card cover is open. Close the card cover.
g
BATTERY EMPTY
The battery is empty. Insert new batteries. When using
rechargeable batteries, charge the
batteries.
Recording has
stopped to allow
camera to cool.
Please wait a
moment. When [IMAGE STABILIZER]
is set to [ON], the camera’s
internal temperature rises
due to continuous movie
recording for a long period,
thereby causing shooting to
stop. Allow the camera to cool down for some
time before you begin shooting again. Or
you can shoot with [IMAGE STABILIZER]
set to [OFF].
Camera is cooling.
Please wait a
moment.
Data in the card cannot be
read. Or, the card is not
formatted. • Select [CLEAN CARD], and press o.
Remove the card and wipe the contact
area with a soft dry cloth.
• Select [FORMAT][YES] and press
o. All data on the card is erased.
OK SET
CARD SETUP
CLEAN CARD
FORMAT
d4364_e_00_unified_bookfile.book Page 76 Friday, December 28, 2007 4:06 PM