Olympus Stylus 600 Digital - Manual (Page 131)

Troubleshooting
131
9
Appendix
Pictures you have taken do not appear on the monitor.
The power is off.
Press the q button to turn the camera on in
playback mode.
P. 10
The camera is in the
shooting mode. Press the q button to switch to playback
mode.
P. 9
There are no pictures in
the internal memory or
on the card. [NO PICTURE] is displayed on the monitor.
Record pictures. –
There is a problem with
the card. See “Error messages”. P. 124
The camera is
connected to a TV. The monitor does not function when the
video cable is connected to the camera. P. 76
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
Cancel the protection of the pictures. P. 78
No picture is displayed on the TV when connected to the camera.
The video output signal
is incorrect.
Set the video output signal according to the
region where used. P. 77
The TV video signal
setting is incorrect. Set the TV to the video input mode. –
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
Use [ s ] to adjust monitor brightness. P. 88
The monitor is exposed
to direct sunlight. Block the sunlight with your hand. –
Frames, titles, or calendars stored in the camera are not displayed.
There is a problem with
the internal memory and
it has been formatted.
Add frames, titles, and calendars to the
camera using OLYMPUS Master software. –
Possible cause Corrective action
Ref.
page