Olympus E-P2 - Manual (Page 58)

58
EN
2
F
oc
u
s
ing and
shootin
g function
s
Setting the focal length
By setting the focal length of the lens in advance, you can
use the image stabilizer function with lenses other than
Micro Four Thirds/Four Thirds system lenses. This setting
is deactivated when a Micro Four Thirds/Four Thirds
system lens is attached.
1
Press the F button when the image stabilizer is
turned on.
2
Use the sub dial to set the focal length and press
i.
Focal lengths that can be set
• If the focal length of the lens you are using is not listed, select the closest value.
x
Notes
• The image stabilizer cannot correct excessive camera shake or camera shake that occurs
when the shutter speed is set to the slowest speed. In these cases, it is recommended that
you use a tripod.
• When using a tripod, set [IMAGE STABILIZER] to [OFF].
• When using a lens with an image stabilization function, turn off the image stabilizer function of
either the lens or the camera.
• If [IMAGE STABILIZER] is set to [I.S.1], [I.S.2] or [I.S.3] and you turn off the camera, the
camera will vibrate. This is due to the camera initializing the image stabilizer mechanism.
• You may notice an operating sound or vibration when the image stabilizer is activated.
• If the image stabilizer icon blinks in red on the monitor, it indicates a failure of the image
stabilizer function. If you take a picture as is, the composition may be off. Consult your
Olympus Authorized Service Center.
• The image stabilizer will not activate at shutter speeds of over 2 seconds.
• If the internal temperature of the camera exceeds the specified temperature, the image
stabilizer is deactivated and the image stabilizer icon lights red on the monitor.
8mm 10mm 12mm 16mm 18mm 21mm 24mm 28mm 30mm 35mm
40mm 48mm 50mm 55mm 65mm 70mm 75mm 80mm 85mm 90mm
100mm 105mm 120mm 135mm 150mm 180mm 200mm 210mm 250mm 300mm
350mm 400mm 500mm 600mm 800mm 1,000mm
P
F F
50 mm 50 mm
AUTO AUTO
FOCAL LENGTH FOCAL LENGTH
1 IS IS
L F
j