Toshiba Tecra A2 - Manual (Page 132)

User’s Manual 8-8
Optional Devices
4. Insert the other end of the cable into the printer’s parallel connector.
5. Fasten the connector to the printer with the clips on the parallel port.
6. Turn on the printer.
7. Turn on the computer.
8. Start the HW Setup program. Refer to Chapter 7,
HW Setup and
Passwords .
9. Select the Parallel/Printer tab from the TOSHIBA HW Setup
window.
10. Set the Parallel Port Mode and press OK.
11. Choose Reboot for the change to take effect.
12. Select the printer in Windows Add Print Wizard. To access the Add
Print Wizard
utility, click Start, point to Settings, click Printers and
double click the Add Printer icon.
Advanced Port Replicator IIl
In addition to the ports available on the computer, the Advanced Port
Replicator lll provides serial port and separate ports for PS/2 mouse and
PS/2 keyboard. The Port Replicator connects directly to the docking
interface on the bottom of the computer. The AC adaptor connects the Port
Replicator to a power source.
The computer must be configured properly before connecting to a LAN.
Logging onto a LAN using the computer’s default settings could cause a
malfunction in LAN operation. Check with your LAN administrator
regarding set-up procedures
.
■ You must connect the AC adaptor before you connect to a Advanced
Port Replicator III.
■ When a Port Replicator III is connected to the computer, you can not
use the following computer’s ports: Modem jack, LAN jack, DC IN 15V
port, USB port, Parallel port, External monitor port.