Toshiba Tecra A2 - Manual (Page 176)

User’s Manual D-3
Wireless LAN
*1 Factory-set default channels
*2 Refer to the sheet Approved Countries/Regions for use for the countries/
regions that in which these channels can be used.
When installing Wireless LAN cards, the channel configuration is managed
as follows:
■ For wireless clients that operate in a Wireless LAN Infrastructure, the
Wireless LAN card will automatically start operation at the channel
identified by the Wireless LAN Access Point. When roaming between
different access points the station can dynamically switch to another
channel if required.
■ For Wireless LAN cards installed in wireless clients that operating in a
peer-to-peer mode, the card will use the default channel 10.
■ In a Wireless LAN Access Point, the Wireless LAN card will use the
factory-set default channel (printed in bold), unless the LAN
Administrator selected a different channel when configuring the
Wireless LAN Access Point device.
Wireless IEEE 802.11 Channels Sets (Revision A)
10 2457* 1
11 2462
12 2467* 2
13 2472* 2
Frequency Range Channel
ID
5150-5850 MHz Note
36 5180
40 5200
44 5220
48 5240
52 5260
56 5280
60 5300
64 5320
149 5745* 3 US only * 4