Lan -19, Lan cable types, Connecting lan cable – Toshiba Portege R200 (PPR21) User Manual
Page 77
User’s Manual
4-19
Operating Basics
LAN
The computer has built-in support for Ethernet LAN (10 megabits per
second, 10BASE-T), Fast Ethernet LAN (100 megabits per second,
100BASE-TX) and Gigabit Ethernet LAN (1000 megabits per second,
1000BASE-T). Some models are equippend with a Gigabit Ethernet LAN.
This section describes how to connect/disconnect to a LAN.
LAN cable types
If you are using Gigabit Ethernet LAN (1000 megabits per second,
1000BASE-T), be sure to connect with a CAT5E cable or higher.
You cannot use a CAT3 or CAT5 cable.
If you are using Fast Ethernet LAN (100 megabits per second,
100BASE-TX), be sure to connect with a CAT5 cable or higher.
You cannot use a CAT3 cable.
If you are using Ethernet LAN (10 megabits per second, 10BASE-T),
you can connect with either a CAT5 or a CAT3.
Connecting LAN cable
To connect the LAN cable, follow the steps below.
Do not install or remove an optional memory module while Wake-up on
LAN is enabled.
■
The Wake-up on LAN function consumes power even when the system
is off. Leave the AC adaptor connected while using this feature.
■
The LAN jack of the Slim Port Replicator supports Ethernet LAN
(10 megabits per second, 10BASE-T) and Fast Ethernet LAN
(100 megabits per second, 100BASE-TX). Gigabit Ethernet LAN
(1000 megabits per second, 1000BASE-T) is not supported.
The computer must be configured properly before connecting to a LAN.
Logging onto a LAN using the computer’s default settings could cause a
malfunction in LAN operation. Check with your LAN administrator
regarding set-up procedures.
■
Connect the AC adaptor before connecting the LAN cable. The AC
adaptor must remain connected during LAN use. If you disconnect the
AC Adaptor while the computer is accessing a LAN, the system may
hang up.
■
Do not connect any other cable to the LAN jack except the LAN cable.
Otherwise, malfunctions or damage may occur.
■
Do not connect any power supplying device to the LAN cable that is
connected to the LAN jack. Otherwise, malfunctions or damage may
occur.