Toshiba L9363 - Manual (Page 89)

89
Eng
lis
h
CONTROLS AND FEATURES
NOTE:
• These functions depend on the device connected.
If you select the HDMI CEC Control input source from
the popup window, some HDMI CEC Control devices
may automatically turn on.
• If the HDMI cable from connected equipment is
changed, Enable in the HDMI CEC Control Setup menu
may need to be reset to On.
• If you change the HDMI lead to a connected device or
change an HDMI device setting, reset the Enable HDMI
CEC Control item on the HDMI CEC Control Setup
menu from Off to On.
When connected equipment is switched on, HDMI CEC
Control will automatically detect the television through the
input selection. If the television is in Standby, it will be
switched on automatically.
These functions can be enabled or disabled from the
HDMI CEC Control Setup (see page 88).
NOTE:
• Even if the equipment is showing a menu, the television
may automatically show the input source.
• This feature depends on the connected equipment and
television state.
If the television is turned off (Standby), the television will
send a message to turn off (Standby) all of the HDMI CEC
Control devices connected to the television.
These functions can be enabled or disabled from the
HDMI CEC Control Setup (see page 88).
NOTE: This feature depends on the connected equipment
and television state.
Using MHL TV function
You can use the following functions by connecting
between the TV HDMI 3 port and a USB port of mobile
phones etc. with an MHL cable.
• Charge with mobile phone from TV
• Two-way remote operation between TV and mobile
phone
• Video/Audio output from mobile phone
NOTE: These functions may not be available depending
on the connected device.
Connect the device to the HDMI 3 port on the TV with an
MHL cable (not supplied).
• When you connect an MHL-compatible device to the
HDMI 3 port on the TV with the MHL cable, charging
starts automatically.
NOTE: Do not connect an MHL-compatible device to any
port other than the HDMI 3 port.
When an MHL-compatible device is connected to the
HDMI 3 port on the TV, input automatically switches to the
HDMI 3 port.
Operate the device using the remote control for the TV. To
display photos, select the photos using
BbC c and
press OK. To play a video, press c (play).
Depending on the connected MHL-compatible device, it
may be possible to perform operations from the device.
Select whether or not input automatically switches to the
HDMI 3 port when an MHL-compatible device is
connected.
a
In the Options menu, press B / b to select MHL
Setup.
b
Press c to select TV Auto Input Switch.
c Press C / c to select On or Off and press OK.
HDMI CEC Control one touch play
HDMI CEC Control system standby
Connecting an MHL-compatible
device
Operating an MHL-compatible
device
MHL Setup
HDMI 3
MHL cable
(not supplied)