Toshiba W2333 User Manual
Page 21
21
English
Switching On
If the RED Standby LED is unlit, check that the plug is connected to the power supply. If the picture
does not appear press on the remote control, it may take a few moments.
To put the television into Standby press on the remote control. To view the television press
again. The picture may take a few seconds to appear.
For energy saving:
We recommend that you use the television with factory settings. These settings are designed for
energy saving. Unplugging the mains plug will reduce energy use to zero. This is recommended
when the television is not being used for long periods, e.g. when on holiday. Reducing the bright-
ness of the screen will reduce energy use. Energy ef
¿ ciency reduces energy consumption and can
save money by reducing electricity bills.
NOTE: Putting the television into standby mode will reduce energy consumption, but will still draw
some power.
Using the Remote Control
To set up the television you will now need to use the on screen menus. Press MENU on the remote
control to see the menus.
The on-screen menu appears as a list of
¿ ve topics. As each symbol is selected by pressing Ż or Ź
on the navigation ring on the remote control.
To use the options, press
to enter the sub menu. Then press
Ÿ or ź on the navigation ring to
move up and down through the menu and use
to select the required choice. Follow the on-
screen instructions. The functions of each menu are described in detail throughout this manual.
Using the Controls on the TV
Press
to adjust volume.
Press
to change programme selection, then press
to adjust programme selection.
Press and hold
until Source List is displayed, then press
to scroll through the list until
desired input source is located.
Please always refer to the owner’s manual of the equipment to be connected for full details.
NOTE: Inserting the headphone plug will mute the sound from all speakers.