Toshiba Magnia Z500 - Manual (Page 15)

MegaRAID Configuration Console
Using MegaRAID Configuration Console
15
To set or change your password, please use program below.
<Local disk>:\Program Files\MegaRAID\Setpass\Setpass.exe
MegaRAID Configuration Console main screen
The screen below displays the MegaRAID Configuration Console
main screen. It is broken up into 5 frames.
Option Description
View Only This allows you to view the RAID configuration only. It does
not allow you to perform rebuilds or check consistency.
Full Access This allows you to view, configure, and manage the Mega-
RAID controller. This option requires you to supply the Full
Access Password.
NOTE: When you install MegaRAID Con-
figuration Console with Server Setup Tool,
the password is set to “megaraid”. Two or
more users cannot connect at the same
time in full Access mode. it takes a few
minutes to log on Full Access mode again
after logging out. Please wait for a while to
log on Full Access mode. you cannot use
MegaRAID Configuration Console and
“Power Console Plus”, which is a utility of
the SCSI RAID controller, at the same time
in Full Access mode.