Toshiba MV732 - Manual (Page 15)

15
SETTING UP YOUR TV
En
glish
m
Use B or b to move through the list to select a
channel, and then press
Q
to view.
In ATV mode, some areas may receive duplicate
stations. There may not be a clear picture or the signal
may be weak, so the station order can be changed
using ATV Manual Tuning.
REMEMBER: Press TV at any time to select between
ATV and DTV (DTV TV/DTV RADIO/DTV TEXT if
available) modes.
NOTE: The time will be set automatically by
transmission but can be advanced or decreased by
using Local Time Setting in the DTV Settings screen.
From this menu, you can set the RF input configuration to cable.
a
Press MENU, and select SETUP menu.
b
Use b to highlight Ant/Cable In and use C or c to
select Antenna or Cable.
NOTE: When you attempt to change the Ant/Cable
In setting, a warning message will appear followed by
PIN entry (if PIN has been set) and a prompt for Auto
Tuning.
c
When Ant/Cable In is set to Cable, the following
setting options will be provided in the Auto Tuning
screen.
Press B or b to select an item, and then press C or c
to select your desired option.
With the exception of DTV Scan Type and DTV Modulation
items, all of the following items will have 2 operating modes.
The first is Auto where the values for each item are preset by
the system. The second is an Input mode where you will be
able to enter a single value in place of the pre-set value. If no
channel is currently tuned and the Input state is chosen, a
system default value will be shown. However, if a channel is
currently tuned when the item is accessed, the value of the
current channel will be displayed.
DTV Scan Type:
This item determines whether a Quick Scan or a Full Scan will
be executed.
The Quick Scan is a simplified version of the Full Scan that is
designed to complete in less time.
DTV Start Frequency:
This sets the frequency from which the scan will begin.
DTV End Frequency:
This sets the frequency at which the scan will end.
* Valid entry range for frequency items is 113.000-
858.00 for C-Book/Other and 114.000-858.00 for
Nordig-C. If numbers outside of this range are
entered, the values will automatically be set to the
min. or max. valid value as appropriate.
DTV Modulation:
You can choose from five QAM modulation settings.
DTV Symbol Rate:
This is the baud rate (KS/s) of the scan.
* Valid entry range for Symbol Rate is 4000-7200. If a
number outside of this range is entered, the value will
be automatically set to the min. or max. valid value as
appropriate.
DTV Network ID:
This is the Network ID to be utilized for the scan. This item is
greyed out when DTV Scan Type is set to “Full Scan”.
* Valid entry range for Network ID is 1-65535. If a
number outside of this range is entered, the value will
be automatically set to the min. or max. valid value as
appropriate.
PLEASE NOTE
The Reset TV menu can also be accessed at any
time from the SETUP menu.
Ant/Cable In (if available)
Auto Tuning
DTV and ATV Tuning Mode
DTV
Quick Scan Scan Type
Auto Start Frequency
Auto End Frequency
Auto Modulation
Auto Symbol Rate
Auto Network ID
Start Scan
RVXVMV73_WebOM_UK.book Page 15 Monday, April 19, 2010 10:46 AM