Toshiba MV732 - Manual (Page 60)

60
CONTROLS AND FEATURES
En
g
li
sh
Some early HDMI equipment may not work properly with your
HDMI TV. Please try setting the Enable Content Type and
INSTAPORT™ options to Off. Adjusting these settings should
allow your early HDMI source to operate properly with your
television.
a
In the PREFERENCES menu, press b until AV
Connection is highlighted, and then press Q .
b
Press b to highlight HDMI Settings and press
Q
.
NOTE: HDMI Settings is grayed out on non-HDMI
inputs.
c
Press B or b to select an item, and then press C or c
to select a setting.
• Enable Content Type: On
This feature is part of the HDMI1.4 standard.
When set to On, the TV will automatically adjust
settings according to the content type data sent from
the connected HDMI device.
• INSTAPORT™: On
This feature reduces the lag time when switching
HDMI sources.
• RGB Range: Auto
This feature adjusts RGB full range signal
automatically. When Limited is selected, RGB signal
is output in the range from 16 to 235. When Full is
selected, RGB signal is output in the range from 0 to
255.
NOTE:
• If your HDMI connection is capable of 1080p and/or your
television is capable of refresh rates greater than 50Hz or
supports Deep Colour, you will need a Category 2 cable.
Conventional HDMI/DVI cables may not work properly with
this mode.
• All of the above HDMI settings need proper HDMI source
devices.
If the HDMI source products do not support these features,
the television may not work properly by activating these
features.
When connecting a surround sound amplifier to the digital
audio output (Sony/Philips Digital Interface Format
[S/PDIF]), the following options can be selected.
PCM: this mode outputs PCM format to the digital audio output
socket.
Auto: this mode outputs Dolby Digital (if available) or PCM to
the digital audio output socket.
Dolby Digital S Dolby Digital
Dolby Digital Plus S Dolby Digital
MPEG S PCM
HE-AAC S Dolby Digital
a
In the AV Connection menu, press b to select Digital
Audio Output.
b
Use C or c to select PCM or Auto.
HDMI Settings
HDMI Settings
Enable Content Type
INSTAPORT TM
On
On
RGB Range Auto
Digital Audio Output
RVXVMV73_WebOM_UK.book Page 60 Monday, April 19, 2010 10:46 AM