Connecting the modular cable – Toshiba Satellite Pro S200 User Manual

Page 104

Advertising
background image

4-30

User’s Manual

TECRA A9, TECRA S5, Satellite Pro S200, Satellite Pro A150

Connecting the modular cable

To connect the modem’s modular cable, follow the steps as detailed below:

1. Plug the end of the modular cable into the computer’s modem jack.

2. Plug the other end of the modular cable into a telephone jack.

Connecting the internal modem

Connection to any communication line other than an analog phone line
could cause a computer system failure.

Connect the built-in modem only to ordinary analog phone lines.

Never connect the built-in modem to a digital line (ISDN).

Never connect the built-in modem to the digital connector on a
public telephone or to a digital private branch exchange (PBX).

Never connect the built-in modem to a key telephone system for
residences or offices.

Never operate your computer on AC power during a thunderstorm. If
you see lightning or hear thunder, immediately turn off the computer.
An electric surge caused by the storm, may result in a system failure,
loss of data or hardware damage.

Telephone jack

Modular cable

Modem jack

Do not pull on the cable or move the computer while the cable is
connected.

If you use a storage device such as an optical drive or hard disk drive
connected to a 16-bit PC Card, you might experience the following
problems with the operation of the modem:

The modem speed is slow or communication is periodically interrupted.

Skips or jumps may be noted in sound.

Advertising
This manual is related to the following products: