Toshiba Satellite Pro S200 - Manual (Page 78)

4-4 User’s Manual
TECRA A9, TECRA S5, Satellite Pro S200, Satellite Pro A150
How to Swipe your Finger
Using the following steps when swiping fingers for fingerprint registration or
authentication will help to minimize authentication failures:
Align the first joint of the finger at the center of the sensor, then lightly touch
the sensor and swipe finger horizontally towards you until the sensor
surface becomes visible. In performing this process, you should also take
care to ensure that the center of your fingerprint is on the sensor.
The following illustrations show the recommended way to swipe your finger
over the fingerprint sensor.
Swipe the finger
Points to note about the Fingerprint Sensor
Please be aware of the following considerations when using the fingerprint
sensor. A failure to follow these guidelines might result in damage to the
sensor, sensor failure, fingerprint recognition problems or a lower
fingerprint recognition success rate.
■
Do not scratch or poke the sensor with your nails or any hard or sharp
objects.
■
Do not press the sensor strongly.
■
Do not touch the sensor with a wet finger or any wet objects - keep the
sensor surface dry and free from water vapor.
■
Do not touch the sensor with a soiled or dirty finger as minute foreign
particles of dust and dirt may scratch it.
■
Do not paste stickers or write on the sensor.
■
Do not touch the sensor with a finger or any other object which may
have a build-up of static electricity on it.
Sensor
Sensor
■
Avoid swiping with your finger stiff or pressed too hard onto the sensor,
and take care to ensure that the center of the fingerprint is touching the
sensor before swiping. Either of these conditions may cause fingerprint
reading to fail.
■
Check the center of the fingerprint whirl before swiping and then
ensure this is swiped along the center line of the sensor.
■
There is a possibility of authentication failures if the finger is swiped too
quickly or too slowly - follow any on-screen instructions to adjust the
speed used during the swipe process.