Belkin F5D7632uk4v3000 - Manual (Page 12)

������ �������� �������� ������ �
� � � �
�����
13 12
Connecting your Router
13 12
3.
If you have a dedicated ADSL service telephone line with an RJ11 wall
jack, simply connect a telephone cord from the wall jack to the gray RJ11
port labeled “DSL line” on the back of your Router.
4.
If you have an RJ45 wall jack for your ADSL service, connect an RJ45-
to-RJ11 converter to the wall jack. Then connect one end of a telephone
cord to the converter and the other end to the gray RJ11 port labeled
“DSL line” on the back of your Router.
Note: ADSL microfilter may or may not be
provided depending on your country.
Powering up your Router
1.
Connect the supplied power adapter to the Router
power-input plug labeled “Power”.
Note: For safety and performance reasons, only use the supplied power
adapter to prevent damage to the Router.
2.
After connecting the power adapter and the power source is turned on,
the Router’s power icon on the front panel should be on. It might
take a few minutes for the Router to fully start up.