Belkin F5D7632uk4v3000 - Manual (Page 72)

73 72
Setting Up your Computers
73 72
Manually Configuring Network
Adapters in Mac OS up to 9.x
In order for your computer to properly communicate with your Router, you
will need to change your Mac computer’s TCP/IP settings to DHCP.
1.
Pull down the Apple menu. Select “Control Panels” and select “TCP/
IP”.
2.
You will see the TCP/IP control panel. Select “Ethernet Built-In” or
“Ethernet” in the “Connect via:” drop-down menu (1).
3.
Next to “Configure” (2), if “Manually” is selected, your Router will
need to be set up for a static IP connection type. Write the address
information in the table below. You will need to enter this information
into the Router.
(1)
(2)