Sharp R-722STWE - Manual (Page 238)

GB-19
OTHER CONVENIENT FUNCTIONS
1. SEQUENCE COOKING
This function allows you to cook using up to 2 diff erent stages which can include manual cooking times
and/or time defrost as well as weight defrost function. Once programmed there is no need to interfere with
the cooking operation as the oven will automatically move onto the next stage. An audible signal will sound
once after the fi rst stage. If one chosen stage is defrosting, this should be the fi rst stage of sequence cooking.
NOTE: AUTO MENU cannot be set as one of the multiple sequences.
Example: If you want to cook food for 20 minutes on P100 microwave power and then for 5 min-
utes with P80 microwave power. The steps are as follows:
- 1. Press the MICRO. POWER button, P100 will appear in the LED display.
- 2. Press the START/ +30sec./ENTER button once to confi rm the setting.
- 3. Enter the cooking time by rotating the ENTRY dial until the display shows “20:00” minutes.
- 4. Press the MICRO. POWER button, P100 will appear in the LED display.
- 5. Press the MICRO. POWER button once again or rotate the ENTRY dial to select the microwave
power to P80.
- 6. Press the START/ +30sec./ENTER button once more to confi rm the setting.
- 7. Enter the cooking time by rotating the ENTRY dial until the display shows “5:00” minutes.
- 8. Press the START/ +30sec./ENTER button to start cooking.
2. +30sec FUNCTION (Auto minute)
Direct start
You can directly start cooking on P100 microwave power level for 30 seconds by pressing the START/
+30sec./ENTER button. The cooking process will start immediately and each time the button is pressed
this will increase the cooking time by 30 sec.
NOTE: The cooking time may be extended to a maximum of 95 minutes.
3. CHILD LOCK:
Use to prevent unsupervised operation of the oven by children.
a. To set the CHILD LOCK:
In the stand-by mode, press STOP/CLEAR button for 3 seconds. There will be a long beep denoting
entering the children-lock state and the
indicator will illuminate together with the current clock
time. If the clock has not been the display status will be as follows:
b. To cancel the CHILD LOCK:
In the stand-by mode, press STOP/CLEAR button for 3 seconds. There will be a long "beep" denoting
that the lock is released.