Sharp MX-7040N - Manual (Page 2)

2
BEFORE FIRST USE
For the users of the fax function
„ Important safety instructions
• If any of your telephone equipment is not operating properly, you should immediately remove it from your telephone line,
as it may cause harm to the telephone network.
• Never install telephone wiring during a lightning storm.
• Never install telephone sockets in wet locations unless the socket is specifically designed for wet locations.
• Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network
interface.
• Use caution when installing or modifying telephone lines.
• Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric
shock from lightning.
• Do not use a telephone to report a gas leak in the vicinity of the leak.
• Do not install or use the machine near water, or when you are wet. Take care not to spill any liquids on the machine.
• Save these instructions.
Caution!
For complete electrical disconnection, pull out the main plug.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
FAX interface cable and Line cable
These special accessories must be used with the device.
The Declaration of Conformity can be viewed at the following URL address. http://www.sharp.de/doc/MX-FX11.pdf
EMC (this machine and peripheral devices)
„ Warning:
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may
be required to take adequate measures.
This machine contains the software having modules developed by Independent JPEG Group.
This product includes Adobe ® Flash ® technology of Adobe Systems Incorporated.
Copyright© 1995-2007 Adobe Macromedia Software LLC. All rights reserved.
PostScript is a registered trademark of Adobe Systems Incorporated.
SOFTWARE LICENCE
The SOFTWARE LICENCE will appear when you install the software from the CD-ROM. By using all or any portion of the
software on the CD-ROM or in the machine, you are agreeing to be bound by the terms of the SOFTWARE LICENCE.
• The explanations in this manual assume that you have a working knowledge of your Windows or
Macintosh computer.
• For information on your operating system, please refer to your operating system manual or the online Help
function.
• The explanations of screens and procedures in this manual are primarily for Windows Vista ® in Windows ®
environments. The screens may vary depending on the version of the operating system.
• This manual contains references to the fax function. However, please note that the fax function is not
available in some countries and regions.
• This manual contains explanations of the PC-Fax driver and PPD driver. However, please note that the
PC-Fax driver and PPD driver are not available and do not appear on the software for installation in some
countries and regions.
In this case, please install the English version if you want to use these drivers.
• Considerable care has been taken in preparing this manual. If you have any comments or concerns about
the manual, please contact your dealer or nearest authorised service representative.
• This product has undergone strict quality control and inspection procedures. In the unlikely event that
a defect or other problem is discovered, please contact your dealer or nearest authorised service
representative.
• Aside from instances provided for by law, SHARP is not responsible for failures occurring during the use
of the product or its options, or failures due to incorrect operation of the product and its options, or other
failures, or for any damage that occurs due to use of the product.
Products that have earned the ENERGY STAR ® are designed to protect the environment
through superior energy efficiency.
The products that meet the ENERGY STAR ® guidelines carry the logo shown above.
The products without the logo may not meet the ENERGY STAR ® guidelines.
„ Warranty
While every effort has been made to make this document as accurate and helpful as possible, SHARP Corporation makes
no warranty of any kind with regard to its content. All information included herein is subject to change without notice.
SHARP is not responsible for any loss or damages, direct or indirect, arising from or related to the use of this operation
manual.
© Copyright SHARP Corporation 2012. All rights reserved. Reproduction, adaptation or translation without prior written
permission is prohibited, except as allowed under copyright laws.
MATERIAL SAFETY DATA SHEET
The MSDS (Material Safety Data Sheet) can be viewed at the following URL address:
http://www.sharp-world.com/corporate/info/index.html.