Sharp MX-7040N - Manual (Page 7)

7
NAMES OF PARTS AND POWER INPUT
The machine has two power switches: The main power switch inside the front cover located in the lower left corner, and the [POWER] button ( ) on the operation panel.
• Please note that the Bypass-tray is standard feature in some countries and
regions.
• When using the fax or Internet fax function, always keep the main power switch in
the "On" position.
• In some machine operating states, restarting using the [POWER] button ( ) may
not make the settings take effect. In this case, turn off the main power switch and
then turn it on again.
Turning on the power
• Turn the main power switch to the " " position.
The main power indicator blinks in green. The [POWER] button
( ) does not function while the main power indicator blinks in
green.
• After the main power indicator lights up green, press the
[POWER] button ( ).
Turning off the power
Turn off the power by pressing the [POWER] button ( ), then turn the
main power switch to the " " position.
Restarting the machine
In order for some settings to take effect, the machine must be restarted.
Follow the message displayed on the touch panel to restart the system
(turn off the power by pressing the [POWER] button ( ) and then press it
again to turn the power back on).
• When turning off the main power switch, make sure that all indicators other than the
main power are turned off.
• In the case of a sudden main power outage, turn the power for the machine back on
and then turn it off in the correct order. If you turn off the main power switch or unplug
the power cord while the indicator is lit up or blinking, the hard disk drive may be
damaged or data may be lost.
• Turn off both the [POWER] button ( ) and the main power switch and unplug the
power cord if you suspect a machine failure, if there is a bad thunderstorm nearby, or
when you are moving the machine.
Caution:
Main power indicator
Main power switch
[POWER] button
Right tray *
Bypass-tray *
Tray 5 (MX-LC12) *
Tray 2
Tray 3
Keyboard *
Operation panel
Saddle finisher *
Front cover (Upper)
Front cover (Lower)
Tray 1
Tray 4
* Optional
Punch module *
Output tray (Centre tray)
USB connector (A type)
Automatic document feeder