Sharp R-23AM - Manual (Page 23)

22
• Do not allow grease or dirt to build up on the door
seals and adjacent parts as this may prevent the
door from closing correctly and may cause a leak-
age of microwaves. To clean use a mild detergent
solution on a soft damp cloth.
• Never use spray cleaners, oven keys or abrasive scour-
ers as these damage the surface of the oven.
• Do not remove the ceramic floor from the oven.
• Do not use commercial oven cleaners, abrasive or
harsh cleaners or scouring pads on any part of your
microwave oven.
• Do not sprinkle water onto the oven directly. It may
cause electric shock, leakage of electricity or damage
of the oven.
• Failure to maintain the oven in a clean condition could
lead to deterioration of the surface that could adversely
affect the life of the appliance and possibly result in a
hazardous situation.
LEANING & MAINTENANCE
C
WARNING
• DO NOT OPERATE the oven without the splash cover
in place.
• DO NOT REMOVE the splash cover UNLESS THE
POWER CORD IS REMOVED FROM THE OUTLET
because the rotary antenna,which is located on the
ceiling, operates for 1 minute after the door is opened
and injury could occur.
• Keep the ceramic floor clean at all times. If you leave
grease or fat in the cavily, it may overheat, smoke or
even catch fire when next using the oven.
SPLASH COVER
AT LEAST ONCE A WEEK, REMOVE THE SPLASH COVER AND WASH BOTH SIDES OF IT IN A MILD DETER-
GENT SOLUTION. A BUILD UP OF GREASE MAY OVERHEAT AND BEGIN TO SMOKE AND MAY BURN THE
SPLASH COVER. THE SPLASH COVER IS LOCATED IN THE TOP OF THE OVEN AND MAY EASILY BE RE-
MOVED. REMEMBER TO UNPLUG THE POWER CORD.
Removal:
1. Remove two thumb screws (A) as shown in Fig.1.
2. Remove the splash cover from the oven.
Reinstall:
1. Insert two projections of the cover (B) into the holes of
the oven cavity backplate as shown in Fig. 2.
2. Secure the cover to the oven ceiling with two thumb
screws (A) as shown in Fig. 1.
Fig. 2
Door Splash cover
(A)
Fig. 1
(B)
Splash cover
Holes
Unplug the oven before removing the removable cover to access oven light bulb, and replace the light bulb (25W/240V).
Make sure that the cover is secured to the oven cabinet after replacing the light bulb. See page 1.
OVEN LIGHT REPLACEMENT