Barco E-2320 C (SE) - Manual (Page 28)

Parts, controls and connectors
28
7. USB upstream port
USB 1.1 standard is supported.
Connect this connector to the PC USB bus if you wish to
connect USB devices to the display’s USB downstream port.
8. DC power input
Connect the external power supply, delivered with the
display, to this connector.
Use supplied power supply only.
9. Tilt & swivel foot clip
The display is shipped with this clip in the foot to protect
the tilt & swivel mechanism during transport. After
unpacking, you should remove this clip.
Do not throw the clip away! Should the display have to be
packed and shipped later, the clip must be applied to the
foot again.
10. Slot for security cable (e.g., Kensington lock)