Barco E-2320 C (SE) - Manual (Page 45)

Display installation
45
To connect the USB cable:
1. Connect the display’s USB upstream connector to the USB
port of the PC by means of a USB cable.
2. Connect any USB device to any of the display’s USB
downstream connectors.
Figure 15
Cable routing
Routing the signal cables
• Bind the cables in the connector compartment together with
the cable tie inside the connector compartment.
• Put the connector compartment cover back on the display. Pay
attention that the signal cables are positioned under the bulge
in the cover.
• Push the cables into the clips on the rear of the tilt & swivel
foot.
• Bind the cables together above and under the foot, by means
of the 2 velcro strips attached to the inside of the foot cover
(packed inside the accessory box).
• At last, put the foot cover back in place.