Billion Electric Company BiPAC 7402VL - Manual (Page 88)

VoIP/(802.11g) ADSL2+ Router
Special dial codes
The following table lists the special dial codes that are built-in to the system:
Option Description
Flash-hook
(Wireless Router with LINE
port only)
Switch to PSTN line
Note: A quick press of the hook. On some phones a button is provided
which provides Flash-hook functionality. The button is marked "FLASH"
or "RECALL".
*69
Return the last missed call for SIP service only
Note: Entering this on a phone will call the last number which made a
call to the phone. For example A makes a call to B, but hangs up before
B answers. If B enters *69, A will be called.
##
Last number redial
*20
Set do not disturb on
Note: It is possible to set a Do-Not-Disturb feature on a phone such that
any phone which calls the phone will receive an engaged tone and the
phone called will not ring. For example, B enters *20 and hangs up. A
makes a call to B, and receives the engaged tone and phone B does not
ring.
*80
Set do not disturb off
*74<x><number>#
Set the number for Speed dial code ‘x’, where ‘x’ is a
number between 2 and 9.
Note: Where <x> is a number between 2 and 9, and <number> is the
number to dial. The code needed to dial a speeddial from a phone
connected to a VoIP Router is:
<x>#, where <x> is a number between 2 and 9.
The settings will infect to your setting in Speed Dial on WEB GUI.
*90<phone-number>
Set the number for performing Blind Call Transfer, where
<phone-number> is the number that you wish to transfer the
call to. It’s for SIP service only.
Note: In Blind Call Transfer, you have a call in progress (incoming or
outgoing) and decide you wish to transfer the call to another phone. To
transfer the call, perform the following steps:
1. Hook-flash to get a dial tone.
2. Dial *90<phone-number> (e.g. *907401), there will be a confirmation
tone then hang up. The other end will hear ring back and the called third-
party phone will ring. When the third-party phone is picked up the two
calls will be connected.
If the third-party phone does not answer then the caller being transferred
can hang up to cancel the connect attempt.
87
Chapter 4: Configuration