Bernina ACTIVA 135 S - Manual (Page 12)

11 Setting up the sewing computer
Sewing table
Increases the sewing surface.
To attach
•
raise the needle and presser
foot
•
place the table over the free
arm and press firmly so that it
engages on the fixing cam
Attaching the presser foot
lifter
Insert into the opening in the
base plate: you should be able
to operate the lifter with your
knee in your normal sitting
position.
Note:
Your dealer can adjust it if
necessary.
Free-Hand-System (FHS) presser foot lifter* (knee-operated)
The presser foot lifter raises
and lowers the presser foot
• push to the right
•
the presser foot is raised
•
the feed-dog is lowered
simultaneously
•
the feed-dog is raised as soon
as the first stitch is sewn
* Special accessory can vary from
country to country
To remove
• raise the needle and presser
foot
•
pull the table out of the
fixing cam
•
pull in horizontal position to
the left
Scale
• «0» corresponds to the centre
needle position
Seam guide
• insert into the groove (under-
side of table) from the right or
left
•
it can be freely adjusted over
the whole width of the table
Note: Remove the presser
foot when attaching the seam
guide!
135_145_S_engl 14.3.2003 15:33 Uhr Seite 11
030529.52.04_0303_a135 a145_EN